dialight corporation ? 1501 route 34 south ? farmingdale, nj 07727 ? tel: (732) 919-3119 ? fax: (732) 751-5778 ?www.dialight.co m 3.2mm round ? optopipe ? optical light pipe, 2 array, panel mounted 515-1033 19.05 [.75] ref 2.79 [.110] ref .61 [.024] .99 [.039] typ diffused front surfaces ? 3.20 [.126] 2 places 1.78 [.07] 4.57 [.18] typ (2) places 13.97 [.550] ? 5.08 [.200] (2) places 4.32 [.17] major dia. ? 3.71 [0.146] press-fi t ribs typ, 3 plcs front panel direction of light .51 [.020] max top surface of led dimensions in mm [inches] leds for use with 515-1033 recommended p age # 521-9247 6-44 521-9249 6-44 521-9251 6-44 550-xx10 6-17 550-5504 6-9 550-5505 6-11 550-5507 6-13 550-5508 6-15 550-5604 6-9 550-5605 6-11 550-5607 6-13 550-5608 6-15 550-5704 6-9 550-5705 6-11 550-5707 6-13 550-5708 6-15 alternatives 521-9430 4-61 521-9431 4-61 521-9432 4-61 led alternatives may not produce optimum light output features ? high transmissivity polycarbonate material ? ul94v-0 compliance ? esd protection (circuit isolation from front panel) ? wide viewing angle ? arrays reduce insertion costs ? secures to panel by press-fit (also recommend supplement means of securing -- for example, clamping) led data for absolute maximum ratings and other electrical and optical data on the recommended leds, refer to led data sheets. dialight optopipe ? light pipe description this optopipe ? is clamped to the inside of the plastic panel. the light pipe is not attached to the pcb at any point but floats in front of it. the splines on the tubular section on the right hand side hold the light pipe in place for the clamping operation. the funnel end faces the light source. the tubular sections fit through the plastic panel. the light emitting sur- face is textured to diffuse the light passing through it. the light source can be any super-bright 2mm, 3mm, or 5mm led, or one of dialight?s 597 series smt leds. the light source?s emitting surface should be located no more than 0.020" or 0.5mm from the optopipe ? . the light sources are mounted in a straight line facing the rear of the light pipe on a 14mm pitch. the light pipe material is water clear transmissive polycarbonate rated ul94-v0, and has a 35% oxygen index. dialight can provide custom optopipe ? solutions for your applications. operating/storage temperature ?30c to +100c
|